ESP Digiview4i Betriebsanweisung PDF herunterladen (Seite 13)

Once the DVR and HDD have been properly installed (please refer to pages

3 ~ 8 for further details about DVR installation) the unit is ready to record

and display. Apply power and switch on.

Following power on, the DVR takes a few seconds checking the HDD. If

a new hard drive is detected, DVR will format the drive automatically.

One of the below messages are displayed:

Press

Pause button 6 times will restore the unit to factory settings. “DVR

Reset Completed” message will be displayed on the monitor and requests a

restart of the DVR.

Switch On the DVR

Before turn on the power, please make sure Video Format is in right position

NTSC Area : North America, Japan, Philippines, Taiwan & etc.

PAL Area : Europe, South America, Australia, Mid-East & Africa

Asian Countries most use PAL like Indonesia, Thailand, Malaysia and etc.

HDD Checking …..

Master 160072 MB.

HDD Checking …..

Master

160072MB

New HDD format completed

Slave

No HDD Detected

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 30 31

Keine Kommentare

ESP Digiview4i Betriebsanweisung Seite 13